The BX5 Carbon studio monitor helps you track, monitor, and mix with confidence by providing accurate sound and dynamic acoustic control. Equipped with
a 5" woven Kevlar low-frequency driver and 1" natural silk dome tweeter, the BX5 Carbon delivers a flat frequency response, enhanced stereo imaging,
and increased clarity for authentic mixing in a space-saving design. The bi-amplified 70 Watt Class A/B amplification means high power with less noise
and ensures that your monitoring setup can handle today's modern music with ease. With the BX5 Carbon, your music is ready for any listening
Sweeter Sweet Spot
The tweeterâ€™s waveguide has been enhanced to provide an expansive sweet spot and superior stereo imaging. A wider mix position gives you professional
monitoring for any caliber studio. Pinhole-mounted LED placement cues help locate and light up the sweet spot to ensure a speaker placement that
reliably translates stereo information and frequencies. When the LEDs turn bright, you know youâ€™re dead center and ready to start mixing your sessions
or laying down tracks with the BX5 Carbon.
Mixing doesnâ€™t occur in a vacuum. Your listening environment influences your mixing decisions and, ultimately, the sound of your music. The BX5
Carbon's Acoustic Space Control, a series of calibration switches, helps provide optimal acoustic conditions for tracking, mixing, and monitoring
anywhere. Adapt the BX5 Carbon to any mixing environment - from bedrooms to basements to professional studios - without compromising frequency detail or
stereo image. The result is a flexible monitoring setup for the most demanding mixing environments.
Type: 2-way near-field studio reference monitors
LF Driver: 6-inch (153mm) Kevlar curved cone with high temperature voice coil and damped rubber surround. Magnetically shielded.
HF Driver: 1.25-inch (32mm) magnetically shielded natural silk dome
Frequency Response: 45 Hz - 22 kHz
Crossover Frequency: 2.5 kHz
LF Amplifier Power: 70 W
HF Amplifier Power: 60 W
Signal-to-Noise Ratio: 100 dB typical A-weighted
1 x XLR balanced input connector
1 x TRS balanced/unbalanced input connector
Polarity: Positive signal at + input produce outward LF cone displacement
Input Impedance: 20 KO balanced, 10 KO unbalanced
Input Sensitivity: 85 mV pink noise input produces 90 dBA output SPL at 1 meter with volume control at maximum
Protection: RF interference, output current limiting, over temperature, turn on/off transient, subsonic filter, external mains fuse.
Indicator: Power on/off indicator on rear panel
Power Requirements: Factory-programmed for 115 V ~50/60 Hz, 230 V ~50/60 Hz, or 100 V ~50/60 Hz